Changing Failure Mode Parameters Dynamically

The input fields for Failure Mode Parameters can accept numbers, expressions and links from other GoldSim elements.  They can also be specified as functions of time. 

Depending on the failure mode type, however, failure mode parameters that are defined as a function of time may not change immediately.  In particular, some parameters are only changed when the mode is repaired or the component is replaced.

The following table categorizes the inputs for each failure mode according to whether changes are reflected immediately, or only after a failure mode has been repaired or the component replaced

 

Failure mode

Changes take effect immediately

Changes take effect when failure mode is repaired or component is replaced

Exponential/Poisson

Failure rate

 

LogNormal

 

Mean (Geom. Mean);

SD (Geom. SD)

Normal

 

Mean;

SD

Uniform

 

Minimum value;

Maximum value

Weibull

 

Mean life (Characteristic life);

Slope factor

Specified Value Exceeded

Value at failure

 

Event triggered failure

Probability of failure

 

Defective component

Failure rate

Probability of defect

Erlang multi-failure

 

Failure rate;

Number of components

Demand>Capacity

Demand;

Capacity

 

Unreliable

Reliability

 

   Note: The Cumulative failure mode does not allow you to change the inputs dynamically since the table must be specified using only numbers (and not equations or links).

Related Topics…

Learn more about: